As a pure two-seater trot, Nissan 350Z has a compact form factor design, while not quite in tune with the appearance of surging power and perfect control performance make this run trot either street or trail running have a remarkable performance. At the same time, this perfect balance of design and performance models in the modified style has a remarkable performance. The car 350Z appeared sufficient to subvert our usual "lady" impression. Wide-body, rivets, metal mounting pole, GT tail, air suspension, the original ladies have hot side. This stock is built tire pressure monitoring system. It looks like a very high-end look. I changed because of the last light night road race did not change much so far light. First take off the dust cover MX5 Coilovers, dig a hole and then the lights to go through, remove the original car headlights, the xenon lamp is inserted into the installation (the plugs are fools everyone will plug one plug). Then it is important to Ballast and decoder to bundle otherwise there will be a strong abnormal sound. Absolutely have to bundle sturdy! So then to get. Lights is very simple, the next navigation module is full toss three and a half hours to get it a bitter a tear Azerbaijan. The four screws to remove the entire panel, you can put this in the control panel operation taken down with the screen Mazda Miata Coilovers. Remove the DVD box navigation module down on eleven lines are also connected to these fools plugs easily. End plug then plug it back into place. I was placed in the right module co-pilot glove box, where you can just have a position can be placed. After these get started navigation test whether the installation was successful. There are 10 satellites, but also good for a long time but less stable when the satellite is fairly good in ten or more. This is the main interface navigation module. Very similar with the original car. After the test begins loading a reversing camera G35 Coilovers. Open the trunk, remove the rubber seal, the left side of the license plate lights are taken down, the camera license plate lamp and putting it back to the main line is not to pull out the camera, so the line by means of a wire hook up, the trunk remove the blanket, put the camera line buried beneath the rear seat from the bottom and then through to the co-pilot glove box. The rear seats recline the rear seats can be inserted into the bottom.